Ford Fiesta Quiz
Engine

Throttle Body. Removal and Installation

In this manual: Engine
Service Information — 27Suspension — 48Transmission — 9Brake System — 52Steering — 21Engine — 140Manual Transmission, Clutch, Transfer Case and Power Transfer Unit — 48Exhaust System — 6Fuel System — 21Climate Control System — 58Instrumentation and Warning Systems — 26Battery and Charging System — 20Infotainment Systems — 41Lighting — 29Power Distribution — 11Electronic Function Group — 30Body and Paint — 275Frame and Mounting — 3
5steps
~30min
2/5difficulty
010203040501511N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Removal

  1. Refer to: Jacking and Lifting – Overview (100-02 Jacking and Lifting, Description and Operation).
    1. Disconnect the quick-release couplings. Refer to: Quick-Release Coupling (310-00B Fuel System - General Information). Information - 1.6 L EcoBoost (132 kW/180 L PS) - Sigma, General Procedures).
    • Release the resonator assembly from the retainer, release the resonator assembly clamp, then remove the resonator assembly from the vehicle.
    1. Remove the CAC outlet pipe locking nut.
      Torque: 133 lb-in (15 N·m)
    1. Loosen the CAC outlet pipe clamps, then remove the CAC outlet pipe.
      Torque: 44 lb-in (5 N·m)
    • Disconnect the throttle body electrical connector and disconnect the throttle body wiring harness retainer from the throttle body.
    • Remove the throttle body bolts, then remove the throttle body.
      Torque: 71 lb-in (8 N·m)
  5. Remove and discard the throttle body gasket.

Installation

NOTICE: Make sure that the mating surfaces are clean and free of foreign material.

  1. To install, reverse the removal procedure.

Test yourself

A quick Ford Fiesta quiz: every answer comes with an explanation and a link to the manual page.