Front Bumper Cover. Disassembly and Assembly

Special Service Tools / General Equipment

Heat gun

DISASSEMBLY

1. 1
   Remove the front bumper cover.
   Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
2. 2
   Remove the front fog lamps.
   Refer to: Front Fog Lamp (417-01 Exterior Lighting, Removal and Installation).
3. 3
   Remove the front park aid sensors, active park aid sensors and related wiring.
   Refer to: Front Park Aid Sensor (413-13A Park Aid System, Removal and Installation).
   Refer to: Front Active Park Aid Sensors (413-13B Park Aid System - Vehicles with: Active Park Aid System, Removal and Installation).
4. 4
   Remove the ambient air temperature sensor.
   Refer to: Ambient Air Temperature Sensor (412-00 Climate Control System - General Information, Removal and Installation).
5. 5
   Release the harness guides and remove the front bumper cover harness.

   

6. 6
   Both sides.
   Remove the push pin and the bracket securing the front bumper cover to the fender.

   

7. 7
   Release the retainers and remove the lower grille.

   

8. 8
   Release the retainers and remove the upper grille.

   

9. 9
   Release the clips and remove the fog lamp face plates.

   

10. 10
    Release the tab and remove the tow hook cover.

    

11. 11
    Remove the push nuts and the front bumper cover emblem.
    Use common equipment: heat gun.

    

ASSEMBLY

1. To install, reverse the removal procedure.