Actuator - Speed Control Servo

1. CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

Disconnect the battery ground cable.

2. Remove the LH wheel and tire; refer to Section.

3. Position aside the LH front splash shield.

1. Remove the pin-type retainers.

2. Remove the screws.

3. Position aside the LH front splash shield.

4. Disconnect the speed control servo electrical connector.

5. Depress the locking tab and rotate the speed control actuator cable cap to remove.

6. Disconnect the speed control cable from the throttle nailhead.

7. Disconnect the speed control actuator cable from the speed control servo pulley.

1. Gently push in the retaining spring.

2. Disconnect the speed control cable slug from the speed control servo pulley.

8. Remove the speed control servo.

1. Remove the bolts.

2. Remove the speed control servo.

Installation

1. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.

To install, reverse the removal procedure.