Ford Mustang Quiz
Body

Inspection and Verification

In this manual: Body
Service Information — 34Suspension — 63Driveline — 80Brake System — 74Steering System — 42Engine — 329Automatic Transmission — 84Manual Transmission, Clutch and Transfer Case — 64Exhaust System — 8Fuel System — 39Climate Control System — 76Instrumentation and Warning Systems — 25Battery and Charging System — 19Audio Systems — 14Lighting — 24Electrical Distribution — 8Electronic Feature Group — 11Body — 173Frame and Mounting — 6General Information — 1
~1min read

1. Verify the customer's concern by operating the active restraint system to duplicate the condition.

2. Inspect to determine if any of the following mechanical or electrical concerns apply:

Visual Inspection Chart

Mechanical Electrical

  • Inspect the safety belt webbing for integrity.
  • Open fuse.
  • Bare, broken or disconnected wire.
  • Connector not tightly engaged.
  • Safety belt warning indicator lamp burned out or broken.

3. If the inspection reveals an obvious concern(s) that can be readily identified, repair as required.

With the exception of removing a twist from the safety belt webbing, do not attempt to repair a component of the safety belt system; new components must be installed.

4. If the concern remains after the inspection, determine the symptom. GO to Symptom Chart .

Symptom Chart

Condition Possible Sources Action
  • The safety belt warning chime does not operate, the safety belt warning indicator lamp is OK
  • Virtual image cluster (VIC).
  • Circuitry.
  • Driver seat module.
  • REFER to Section
  • The safety belt warning indicator lamp does not operate, the safety belt warning chime is OK
  • Burned-out bulb.
  • Circuitry.
  • Driver seat module.
  • REFER to Section
  • Neither the safety belt warning chime nor the safety belt warning indicator lamp operates
  • Safety belt buckle switch.
  • Driver seat module.
  • Circuitry.
  • REFER to Section
  • Excessive pressure on the occupant during normal wear, the webbing cannot be extracted, excessive slack in webbing does not retract
  • Front safety belt retractor and tongue.
  • Rear safety belt retractor and tongue.
  • Carry out the Functional Test. REFER to Component Test.

    INSTALL a new retractor and tongue if necessary

Test yourself

A quick Ford Mustang quiz: every answer comes with an explanation and a link to the manual page.