Front Brake Caliper Overhaul

caution

Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health. Avoid breathing dust particles. Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.

notice

Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.

Remove, disassemble, inspect, reassemble, and install the caliper, and note these items:

• Make sure that the caliper pins are installed correctly. Upper caliper pin B and lower caliper pin A are different. If these caliper pins are installed in the wrong location, it will cause vibration, uneven or rapid pad wear, and possibly uneven tire wear.

• To prevent dripping brake fluid, cover disconnected hose joints with rags or shop towels.

• Clean all parts in brake fluid and air dry; blow out all passages with compressed air.

• Before reassembling, check that all parts are free of dirt and other foreign particles.

• Replace parts with new ones as specified in the illustration.

• Make sure no dirt or other foreign matter gets in the brake fluid.

• Make sure no grease or oil gets on the brake discs or the pads.

• When reusing brake pads, always reinstall them in their original positions to prevent loss of braking efficiency.

• Do not reuse drained brake fluid. Use only new Honda DOT 3 Brake Fluid from an unopened container. Using a non-Honda brake fluid can cause corrosion and shorten the life of the system.

• Coat the piston, the piston seal groove, and the caliper bore with clean brake fluid.

• Use recommended greases in the front caliper set.

• After installing the caliper, check the brake hose and line for leaks, interference, and twisting.

• Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your hands or gloves.

• Refer to the Exploded View as needed during this procedure.