Body (Interior and Exterior)

Center Pillar Trim Repair Procedures

10steps
~60min
3/5difficulty
Done 0 of 10

Replacement

[Center Pillar Lower Trim]
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • When removing interior trim components, use a plastic panel removal tool to avoid damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Carefully remove the front door side weatherstrip.
  2. Carefully remove the rear door body side weatherstrip.
  3. Remove the front door sill trim. (Refer to Interior Trim - "Door Scuff Trim")
  4. Remove the rear door sill trim. (Refer to Interior Trim - "Door Scuff Trim")
  5. Using a screwdriver or removal tool, remove the center pillar lower trim (A).
  6. To install, reverse the removal procedure.
    • Replace any damaged clips (or pin-type retainers).
[Center Pillar Upper Trim]
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • When removing interior trim components, use a plastic panel removal tool to avoid damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the lower center pillar trim. (Refer to Interior Trim - "Center Pillar Trim")
  2. Remove the seat belt anchor connector. (Refer to Retractor - "Emergency Fastening Device (EFD)").
  3. Using a screwdriver or removal tool, remove the center pillar upper trim (A).
  4. To install, reverse the removal procedure.
    • Replace any damaged clips (or pin-type retainers).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.