Rear Luggage Compartment Trim Repair Procedures

Replacement

Wear gloves to avoid cutting your hands.

When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components. Use a plastic panel removal tool to remove the interior trim parts without damaging the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
2. 2
   Remove the rear seatback assembly. (Refer to Rear Seat - "Rear Seat Assembly")
3. 3
   Slightly remove the rear door weatherstrip.
4. 4
   Remove the rear door sill trim. (Refer to Interior Trim - "Door Scuff Trim")
5. 5
   Remove the rear pillar trim. (Refer to Interior Trim - "Rear Wheel House Trim")
6. 6
   Loosen the clips and screws, then remove the side trim of the luggage partition (A).

   

7. 7
   Using a screwdriver or a trim remover, remove the rear wheel arch trim (A).

   

8. 8
   Loosen the mounting bolt, then remove the lower anchor of the rear seat belt (A).

   Tightening torque: 39.2 ~ 54 N·m

   [Side]

   

   [Center]

   

9. 9
   Using a screwdriver or a trim remover, remove the parcel tray cover (A).

   

10. 10
    To install, reverse the removal procedure.

    Replace any damaged clips (or pin-type retainers).