Hyundai Elantra AD Quiz
Restraints

Emergency Front Belt Fixing Device (EFD) Repair Procedures

In this manual: Restraints
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
20steps
~120min
4/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 20

Removal

  1. Disconnect the negative battery cable and wait at least 3 minutes before starting work.
  2. Remove the front seat. (Refer to Body - "Front Seat Assembly")
  3. Remove the rear seat. (Refer to Body - "Rear Seat Assembly")
  4. Disconnect the front seat belt (A) from the Emergency Front Belt Fixing Device.
  5. Remove the door scuff plate. (Refer to Body - "Interior Trim")
  6. Remove the center pillar trim. (Refer to Body - "Interior Trim")
  7. Remove the floor carpet assembly. (Refer to Body - "Floor Carpet")
  8. Disconnect the EFD connector (A).
  9. Remove the EFD (A) after loosening the mounting bolt.

Installation

  1. Disconnect the negative (-) battery cable and wait at least three minutes.
  2. Install the EFD using the mounting bolt.

    Tightening torque: 39.2 ~ 54 N·m

  3. Connect the EFD connector (A).
    • Make sure the stopper pin is inserted correctly.
  4. Install the floor carpet assembly. (Refer to Body - "Floor Carpet")
  5. Install the center pillar trim. (Refer to Body - "Interior Trim")
  6. Install the door scuff plate. (Refer to Body - "Interior Trim")
  7. Connect the front seat belt to the Emergency Front Belt Fixing Device.
  8. Install the rear seat. (Refer to Body - "Rear Seat Assembly")
  9. Install the front seat. (Refer to Body - "Front Seat Assembly")
  10. Connect the negative battery cable.
  11. After installing the EFD system, check the system operation: Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.