Seat Belt Pretensioner (BPT) Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least three minutes before starting work.
2. 2
   Disconnect the front seat belt (A) from the Emergency Front Belt Fixing Device.

   

3. 3
   Remove the door scuff plate. (Refer to Body - "Interior Trim")
4. 4
   Remove the center pillar trim. (Refer to Body - "Interior Trim")
5. 5
   Remove the upper anchor bolt of the front seat belt.

   

6. 6
   Disconnect the front seat belt pretensioner connector (A).

   

7. 7
   Remove the seat belt pretensioner (A) after loosening the seat belt pretensioner mounting bolts.

   

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable and wait at least three minutes.
3. 3
   Install the seat belt pretensioner. Tightening torque: Bolt A: 7.8 ~ 11.8 N·m Bolt B: 39.2 ~ 54 N·m

   

4. 4
   Connect the seat belt pretensioner connector.

   Make sure the stopper pin is inserted correctly.

5. 5
   Install the upper anchor bolt of the front seat belt.

   Tightening torque: 39.2 ~ 54 N·m

   

6. 6
   Install the center pillar trim. (Refer to Body - "Interior Trim")
7. 7
   Install the door scuff plate. (Refer to Body - "Interior Trim")
8. 8
   Connect the negative battery cable.
9. 9
   After installing the seat belt pretensioner, check the system operation:

   A.	Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.