Hyundai Elantra AD Quiz
Engine Mechanical System

Engine Mount Repair Procedures

In this manual: Engine Mechanical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
19steps
~114min
4/5difficulty
04080120160200107.980N·mlb·ft
Tightening torque found on this page
Done 0 of 19

Removal and Installation

Engine Mounting Bracket
  1. Remove the engine compartment cover. (Refer to Engine and Transaxle Assembly - "Engine Compartment Under Cover")
  2. Place a jack under the edge of the oil pan to support the engine.
    • Place a rubber block between the jack and the oil pan to prevent damage to the oil pan.
  3. Remove the engine mount support bracket (A). Tightening torque: Nut (B): 88.3 ~ 108 N·m Bolt, nut (C): 58.8 ~ 74 N·m
  4. Remove the engine mounting bracket (A).

    Tightening Torque: 49.0 ~ 64 N·m

  5. Install in the reverse order of removal.
  6. Remove the engine compartment cover. (Refer to Engine and Transaxle Assembly - "Engine Compartment Under Cover")
  7. Remove the roller rod bracket (A). Tightening torque: Bolts (B): 49.0 ~ 64 N·m Nut (C): 107.9 ~ 128 N·m
  8. Remove the roller rod bracket (A).

    Tightening Torque: 49.0 ~ 69 N·m

  9. Install in the reverse order of removal.
  10. Remove the air duct and air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleaner")
  11. Remove the battery. (Refer to Engine Electrical System - "Battery")
  12. Remove the ECM (Engine Control Module). (Refer to Engine Control/Fuel System - "Engine Control Module (ECM)")
  13. Remove the battery tray. (Refer to Engine Electrical System - "Battery")
  14. Remove the engine compartment cover. (Refer to Engine and Transaxle Assembly - "Engine Compartment Under Cover")
  15. Place a jack under the transaxle to support it.
  16. Remove the service cover (A).
  17. Remove the bolts securing the transaxle support bracket (A).

    Tightening torque: 88.3 ~ 108 N·m

  18. Remove the transaxle mounting bracket (A).

    Tightening Torque: 49.0 ~ 64 N·m

  19. Install in the reverse order of removal.
Roller Rod Bracket, Transaxle Mounting Bracket

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.