Hyundai Elantra AD Quiz
Body Electrical System

Front Washer Motor Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
22steps
~132min
4/5difficulty
Done 0 of 22

Inspection

Front Washer Motor
  1. After connecting the washer motor to the reservoir, fill the reservoir with water.
    • Before filling the reservoir with water, check the filter for foreign material or contamination. If necessary, clean the filter.
  2. Connect the positive (+) battery cable to terminal 2 and the negative (-) battery cable to terminal 1.
  3. Make sure the motor operates normally, the washer motor runs, and water is sprayed from the front nozzles.
  4. If they are not normal, replace the washer motor. [Front and Rear Washer]
    No Description
    1 Ground
    2 Windshield washer (+)

  5. Disconnect the negative (-) battery terminal.
  6. Drain less than 650 mL of washer fluid.
  7. Check the continuity between terminals No. 1 and No. 2 at each float position. There should be continuity when the float is down. There should be no continuity when the float is up.
  8. If the continuity does not meet the specification, replace the washer fluid level sensor.
Washer Fluid Level Sensor Switch

Removal
  • When servicing the washer pump, be careful not to damage the washer pump seal.
  • Do not operate the washer pump until the washer reservoir is filled. Failure to do so may cause premature pump failure.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the right front wheel guard. (Refer to Body - "Front Wheel Guard")
  3. Remove the engine room cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")
  4. Disconnect the washer hose (B) and the washer motor connector (A).
  5. Remove the washer reservoir inlet (A) after loosening the mounting bolt.
  6. Remove the washer motor (B) after disconnecting the fixing hook (A).
  7. Remove the level sensor switch (A).

Installation

  1. Install the washer reservoir.
    • Before installing the washer motor, check the filter for foreign material or contamination. If necessary, clean the filter.
  2. Install the washer motor.
  3. Install the washer hose.
  4. Connect the washer motor connector and the level sensor connector.
  5. Install the wheel guard and the guide cover. (Refer to Body - "Front Wheel Guard")
  6. Install the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")
  7. Check the operation of the washer motor.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.