Hyundai Elantra AD Quiz
Engine Control System/Fuel System

Fuel Pump Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
7steps
~47min
3/5difficulty
1special tools
030609012015068.651N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Removal

  1. Release the fuel line residual pressure. (Refer to Fuel System - "Release Fuel Line Residual Pressure")
  2. Remove the rear seat. (Refer to Body - "Rear Seat Assembly")
  3. Remove the fuel pump service cover (A).
  4. Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
  5. Disconnect the quick-connector of the fuel feed tube (C) and the quick-connector of the vent tube (D).
  6. Remove the fuel pump from the fuel tank after removing the snap ring (E) using the SST [SST: 09310-F3100].
  7. Remove the fuel pump from the fuel tank.

Installation

  1. Installation is the reverse of removal.
    • When installing, make sure the direction of the fuel pump is correct (align with the groove in the fuel tank).
    Fuel pump cover installation: 58.8 ~ 69 N·m

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.