Hyundai Elantra AD Quiz
Body Electrical System

Hazard Warning Switch Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Check the continuity between the terminals. If continuity is not as specified, replace the hazard warning switch.
    Manual (Auto)

Removal
  • Wrap the screwdriver or puller tool with protective tape.
  • Handle with care during storage and during disassembly/assembly, as it is easily contaminated by grease and oil.
  • Be careful not to scratch or break the trim panel and the upper part of the door trim, as well as the wood grain (real wood) garnish.
  • Be careful not to scratch the door trim and other parts.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the glove box upper cover assembly. (Refer to Body - "Glove Box Upper Cover Assembly")
  3. Loosen the mounting screws and remove the center lower cover of the [LH] airbag (A).
  4. Loosen the mounting screws, then remove the air conditioner and heater control assembly (A).
  5. Disconnect the connectors of the air conditioner and heater controller (A) and the hose (B).

Installation

  1. Install the center control panel switch assembly.
  2. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.