Hyundai Elantra AD Quiz
Body Electrical System

Room Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
11steps
~66min
3/5difficulty
Done 0 of 11

Removal

[Room Lamp]
  1. Disconnect the negative (-) battery terminal.
  2. Using a screwdriver or removal tool, separate the room lamp lens (A) from the room lamp.
    • Wear gloves to avoid cutting your hands.
    • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  3. If the bulb must be replaced, remove the bulb (A) after disconnecting the room lamp lens.
  4. Disconnect the room lamp (B) after loosening the mounting screws.
    • When removing the room lamp, pay attention to the direction in which the tool is inserted.
    • Be careful when inserting the tool in the opposite direction, as the room lamp may be damaged.
  5. Remove the room lamp assembly after disconnecting the room lamp connector.
  6. Separate the vanity lamp (A) from the roof trim by disconnecting the mounting clip (B).
[Vanity Lamp]

Installation

[Room Lamp]
  1. Install the room lamp after connecting the connector.
  2. Install the room lamp lens.
  3. Connect the negative (-) battery terminal.
  4. Install the vanity lamp.
  5. Connect the negative (-) battery terminal.
[Vanity Lamp]

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.