Hyundai Elantra AD Quiz
Engine Mechanical System

Rear Oil Seal Repair Procedures

In this manual: Engine Mechanical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
5steps
~40min
3/5difficulty
2special tools
Done 0 of 5

Removal

  1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle")
  2. Remove the drive plate. (Refer to Cylinder Block - "Drive Plate")
  3. Remove the rear oil seal (A).

Installation

  1. Install a new rear oil seal.
    1. Apply engine oil to the lip of the new oil seal.
    2. Using the SST (09231-H1100, 09214-2E000) and a hammer, drive the oil seal (A) until the SST surface is flush with the rear end face of the cylinder block.
  2. Install the remaining parts in the reverse order of removal.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.