Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Rear Seat Cushion Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
3steps
~23min
2/5difficulty
1special tools
Done 0 of 3

Replacement
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • When removing interior trim components, use a plastic panel removal tool to avoid damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  2. After removing the hook-and-loop fastener (A) and the retaining clips with retaining rings (B) inside the rear seat cushion cover, remove the seat cushion cover (C). [Front]
    [Rear]
  3. To install, reverse the removal procedure.
    • Make sure the connectors are fully connected.
    • Replace any damaged clips (or pin-type retainers).
    • To prevent wrinkles, make sure the cover (B) is stretched evenly before connecting the clips (A).
    • Replace the ring clips with new ones using the special service tool (C) (09880-4F000).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.