Hyundai Elantra AD Quiz
Engine Mechanical System

Water Temperature Control Assembly Repair Procedures

In this manual: Engine Mechanical System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
10steps
~60min
3/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 10

Removal and Installation

  1. Remove the engine cover. (Refer to Engine and Transaxle Assembly - "Engine Cover")
  2. Drain the engine coolant so that the level is below the water temperature control assembly. (Refer to Cooling System - "Engine Coolant")
  3. Remove the air duct and air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleaner")
  4. Disconnect the upper radiator hose (A).
  5. Disconnect the heater hoses (A).
  6. Disconnect the bypass hose (A) and the throttle body coolant hose (B) (if equipped).
  7. Remove the water temperature control assembly (A) with the O-ring.

    Tightening torque: 9.8 ~ 11.8 N·m
    • Install a new O-ring.
    • Clean the O-ring contact surface and install the O-ring after wetting it with water.
  8. Install in the reverse order of removal.
  9. Fill the engine with engine coolant. (Refer to Cooling System - "Engine Coolant")
  10. Start the engine and check for leaks.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.