Hyundai Genesis DH Quiz
Restraints

Emergency Front Belt Fixing Device (EFD) Repair Procedures

In this manual: Restraints
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
12steps
~72min
3/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Removal

  1. Disconnect the negative battery cable and wait at least three minutes before starting work.
  2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")
  3. Remove the front seat outer cover. (Refer to Body - "Front Seat Outer Cover")
  4. Disconnect the EFD system connector.
  5. Unscrew the front seat assembly mounting bolt, then remove the EFD system (A).

Installation

  1. Disconnect the negative (-) battery cable and wait at least three minutes.
  2. Install the EFD system with the mounting bolt.

    Tightening torque: 39.2 ~ 54 N·m

  3. Connect the EFD system connector.
  4. Install the front seat outer cover. (Refer to Body - "Front Seat Outer Cover")
  5. Install the front seat assembly. (Refer to Body - "Front Seat Assembly")
    Make sure the stopper pin is inserted correctly.
  6. Connect the negative battery cable.
  7. After installing the EFD system, check system operation: Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.