Hyundai Genesis DH Quiz
Restraints

Pre-activeSeat Belt (PSB) Repair Procedures

In this manual: Restraints
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
12steps
~72min
3/5difficulty
02040608010053.940N·mlb·ft
Tightening torque found on this page
Done 0 of 12

Removal

  1. Disconnect the negative battery cable and wait at least three minutes before starting work.
  2. Remove the front seat belt anchor (A).
    ? Method for disconnecting the anchor seat belt 1) Expose the red indicator pin (A) by pressing the slot with a pointed tool of 1.5 mm, as shown in the figure below.2) Insert a (-) screwdriver (4 mm) into the latch hole () and turn it clockwise. 3) Remove the connector by pulling the seat belt ( ).
    When connecting the anchor connector, secure it firmly until you hear a click.
  3. Remove the lower center pillar trim. (Refer to Body - "Center Pillar Trim")
  4. Remove the upper center pillar trim. (Refer to Body - "Center Pillar Trim")
  5. Loosen the mounting bolt, then remove the lower front seat belt anchor (A).

    Tightening torque: 39.2 ~ 54 N·m

  6. Loosen the front seat belt guide tongue mounting bolts (A).
  7. After releasing the pretensioner connector lock, disconnect the front seat belt pretensioner connectors (A), loosen the mounting bolts, then remove the front seat belt pretensioner (B).

    Tightening torque (C): 39.2 ~ 54 N·m

    [General Type]
    [PSB Option Type]

Installation

  1. Turn the ignition off.
  2. Disconnect the negative battery cable and wait at least three minutes.
  3. Install in the reverse order of removal.
  4. Connect the negative battery cable.
  5. After installing the seat belt pretensioner, check system operation: Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.