Hyundai Genesis DH Quiz
Engine Mechanical System

Engine Mount Repair Procedures

In this manual: Engine Mechanical System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
29steps
~174min
4/5difficulty
030609012015083.462N·mlb·ft
Tightening torque found on this page
Done 0 of 29

Removal and Installation

Left Engine Mount Insulator
  1. Disconnect the negative (-) battery cable from the battery.
  2. Remove the engine cover.
  3. Remove the engine under cover.
  4. Remove the engine room cover and upper radiator grille cover. (Refer to Engine and Transaxle Assembly - "Engine Cover")
  5. Remove the steering joint mounting bolts (A). (Refer to Steering System - "Steering Column and Shaft")
  6. Remove the engine oil level sensor. (Refer to Lubrication System - "Oil Level Gauge and Tube")
  7. Remove the water supply pipe. (Refer to Cooling System - "Water Temperature Control Unit")
  8. Remove the exhaust manifold. (Refer to Intake and Exhaust System - "Exhaust Manifold")
  9. Install the engine oil pan (A) jack.
    Insert the rubber block between the jack and the upper oil pan.
  10. Remove the upper nut (A) of the left engine mount insulator, then remove the mount bracket (B).

    Tightening torque: 63.7 ~ 83 N·m

  11. Remove the engine mount insulator (A).

    Tightening Torque: 49.0 ~ 64 N·m

  12. To install, reverse the removal procedure.
  13. Disconnect the negative (-) battery cable from the battery.
  14. Remove the engine cover.
  15. Remove the engine room cover and upper radiator grille cover. (Refer to Engine and Transaxle Assembly - "Engine Cover")
  16. Remove the air cleaner. (Refer to Intake and Exhaust System - "Air Cleaner")
  17. Remove the engine under cover.
  18. Remove the water outlet pipe. (Refer to Cooling System - "Water Temperature Control Unit")
  19. Remove the exhaust manifold. (Refer to Intake and Exhaust System - "Exhaust Manifold")
  20. Install the engine oil pan (A) jack.
    Insert the rubber block between the jack and the upper oil pan.
  21. Remove the upper nut (A) of the right engine mount insulator, then remove the mount bracket (B).

    Tightening torque: 63.7 ~ 83 N·m

  22. Remove the right engine mount insulator (A).

    Tightening Torque: 49.0 ~ 64 N·m

  23. To install, reverse the removal procedure.
  24. Disconnect the negative (-) battery cable from the battery.
  25. Remove the engine under cover.
  26. Support the transaxle assembly with a jack.
  27. Remove the transaxle mounting bracket (A).

    Tightening Torque: 49.0 ~ 64 N·m

  28. Remove the transaxle mount insulator (A).

    Tightening Torque: 49.0 ~ 64 N·m

  29. To install, reverse the removal procedure.
Right Engine Mount Insulator, Transaxle Mount Insulator

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.