Floor Console Assembly Repair Procedures

Replacement

Wear gloves to avoid cutting your hands.

When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components. When removing interior trim components, use a plastic panel removal tool to avoid damaging the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Remove the shift lever knob and boots (A) by pulling them vertically.

   Be careful when removing the shift lever knob because, unlike some models, turning it to remove may damage the shift lever knob.

   Insert the shift lever knob onto the shift lever, then press it with a rubber mallet (pressure: 55±10 kgf). Continue pressing until the installation line on the rod is no longer visible.

   

2. 2
   Using a screwdriver or remover, remove the front console upper cover (A).

   

3. 3
   Disconnect the connectors (A).

   

4. 4
   Using a screwdriver or remover, remove the console side cover (A). [LH]

   

   [RH]

   

5. 5
   Disconnect the floor console main connector (A).

   

6. 6
   Remove the console armrest (A).

   

7. 7
   Remove the console armrest service cover (A).

   

8. 8
   Disconnect the multimedia jack connectors (A).

   

9. 9
   Loosen the mounting screws and bolts, then remove the floor console assembly (A).

   

10. 10
    Install in the reverse order of removal.

    Make sure the connector is properly connected. Replace any damaged clips.