Hyundai Genesis DH Quiz
Body (Interior and Exterior)

Rear Console Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
5steps
~30min
2/5difficulty
Done 0 of 5

Replacement
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • When removing interior trim components, use a plastic panel removal tool to avoid damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly")
  2. Remove the floor console armrest. (Refer to Floor Console - "Front Console Armrest".)
  3. Loosen the mounting screws (A) located on the top and rear sides of the rear console cover.
  4. Disconnect the connector (A).
  5. Install in the reverse order of removal.
    • Make sure the connector is properly connected.
    • Replace any damaged clips.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.