Hyundai Genesis DH Quiz
Body (Interior and Exterior)

Rear Seat Assembly Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
8steps
~48min
2/5difficulty
0102030405029.422N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Replacement

[Rear Seat Cushion Assembly]

  1. Remove the rear seat cushion assembly (A) by pulling it upward.

    Tightening torque: 19.6 - 29 N·m

  2. Disconnect the rear seat cushion extension connector (A).
  3. Install in the reverse order of removal.
    • Make sure the connector is properly connected.

[Rear Seat Back Assembly]

  1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  2. Loosen the mounting bolts, then remove the rear seat back assembly (A) by pulling it upward.
    ? Removing the Outer Hook
    • Release the hook by pressing the front (A) and rear (B) grooves until you hear a click, using an awl or pin.
  3. Loosen the mounting bolts, then remove the rear seat back assembly (A) by pulling it upward.

    Tightening torque: 19.6 - 29 N·m

  4. Disconnect the rear seat back extension connector (A) and the airbag connector (B). [LH]
    [RH]
  5. Install in the reverse order of removal.
    • Make sure the connector is properly connected.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.