Hyundai Genesis DH Quiz
Body (Interior and Exterior)

Rear Seat Cushion Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
3steps
~23min
2/5difficulty
1special tools
Done 0 of 3

Replacement
  • Wear gloves to protect your hands.
  • When prying with a flat-tip screwdriver or a trim tool, wrap the tool with protective tape and apply protective tape to the surrounding parts to prevent damage.
  • Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  2. Remove the ring clips inside the rear seat cushion cover, then remove the rear seat cushion cover (A). [Rear side]
    [Front side]
  3. Install in the reverse order of removal.
    • Remove the ring clips (A) inside the rear seat cushion cover, then remove the rear seat cushion cover (B).
    • Replace the ring clips with new ones using the special service tool (C) (09880-4F000).

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.