Hyundai i20 Quiz
Restraint

PAB ON/OFF Repair Procedures

In this manual: Restraint
General Information — 17Engine Mechanical System — 79Engine Electrical System — 50Emission Control System — 22Engine/Fuel Control System — 107Clutch System — 27MANUAL TRANSMISSION SYSTEM — 21Drive Shaft and Axle — 18Suspension System — 29Steering System — 21Restraint — 41Braking System — 53Body Work (Interior and Exterior) — 190Body Electrical System — 181Heating, Ventilation and Air Conditioning — 58
11steps
~66min
3/5difficulty
Done 0 of 11

DEPOSIT

  1. Remove the key from the ignition switch.
  2. Disconnect the negative battery cable and wait at least three minutes before starting work.
  3. Remove the side cover from the airbag. (Refer to Body - "Instrument Panel")
  4. Disconnect the PAB ON/OFF switch connector.
  5. Remove the PAB ON/OFF switch.

REMEDY

  1. Remove the key from the ignition switch.
  2. Disconnect the negative battery cable and wait at least three minutes before starting work.
  3. Install the PAB ON/OFF switch on the side panel of the crash pad.
  4. Connect the PAB ON/OFF switch connector to the side cover of the instrument panel.
  5. Remove the instrument panel side trim. (Refer to Body - "Instrument Panel")
  6. After installing the SRSCM, check that the system operates correctly:
    • Turn the ignition switch to ON; the SRS warning lamp should illuminate for approximately six seconds and then turn off.

Test yourself

A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.