Curtain Airbag (CAB) Module Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least 3 minutes before starting work.
2. 2
   Remove the roof headlining. (Refer to Body - "Roof Headlining Assembly")
3. 3
   Remove the curtain airbag (B) after disconnecting the curtain airbag wire harness connector (A) and loosening the mounting bolts.

   

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable and wait at least three minutes.
3. 3
   Tighten the curtain airbag mounting bolts and nuts.

   Tightening torque: Bolt: 7.8–11.8 N·m

4. 4
   Connect the curtain airbag connector.
5. 5
   Install the roof trim. (Refer to Body - "Roof Trim Assembly")
6. 6
   Connect the negative battery cable.
7. 7
   After installing the curtain airbag (CAB), check that the system operates correctly:

   • Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.