Hyundai Kona Quiz
Restraints

Repair Procedures of Side Airbag (SAB) Module

In this manual: Restraints
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
11steps
~66min
3/5difficulty
Done 0 of 11

Removal

  1. Disconnect the negative battery cable and wait at least 3 minutes before starting work.
  2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")
  3. Remove the front seatback rear cover. (Refer to Body - "Front Seatback Cover")
  4. Remove the side airbag (A) after loosening the side airbag mounting nuts.

Installation

  1. Remove the ignition key from the vehicle.
  2. Disconnect the negative battery cable and wait at least three minutes.
  3. Install the front seatback rear cover. (Refer to Body - "Front Seatback Cover")
  4. Install the front seat assembly. (Refer to Body - "Front Seat Assembly")
  5. Tilt and fully slide the front seat forward. Make sure the wire harness is not pinched or interfering with other parts.
  6. Connect the negative battery cable.
  7. After installing the side airbag (SAB), check that the system operates correctly:
    • Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.