Repair Procedures of Passenger Airbag (PAB) Module

Removal

1. 1
   Disconnect the negative battery cable and wait at least three minutes before starting work.
2. 2
   Remove the glove box housing. (Refer to Body - "Glove Box Upper Cover Assembly")
3. 3
   Loosen the passenger airbag mounting bolts.

   

4. 4
   Disconnect the passenger airbag connector (A).

   

5. 5
   Remove the crash pad. (Refer to Body - "Crash Pad Main Assembly")
6. 6
   Remove the passenger airbag from the instrument panel after loosening the mounting bolts.

   

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable from the battery and wait at least three minutes before starting work.
3. 3
   Place the passenger airbag on a protective cushion and tighten the airbag mounting bolts.

   Tightening torque: 4.0–6 N·m

   

4. 4
   Install the crash pad. (Refer to Body - "Crash Pad Main Assembly")
5. 5
   Connect the passenger airbag wire harness connector to the main SRS wire harness connector (A).

   

6. 6
   Tighten the passenger airbag mounting bolts.

   Tightening torque: 7.8–11.8 N·m

   

7. 7
   Install the glove box. (Refer to Body - "Crash Pad Center Panel")
8. 8
   Connect the negative battery cable.
9. 9
   After installing the passenger airbag (PAB), check that the system operates correctly:

   • Turn the ignition ON; the SRS indicator should illuminate for about six seconds and then go off.