Front Washer Motor Repair Procedures

Inspection

1. 1
   Connect the washer motor to the reservoir, then fill the reservoir with washer fluid.
2. 2
   Connect the positive (+) battery cable to terminal 2 and the negative (-) battery cable to terminal 1, respectively.
3. 3
   Make sure the motor operates normally and the washer motor works and sprays water from the front nozzles.
4. 4
   If they are abnormal, replace the washer motor. [Front and rear washer]

   No	Description
   1	Windshield washer (+)
   2	Ground
   3	Rear Washer (+)

   
   

   

Removal

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the right front wheel guard. (Refer to Body - "Front Wheel Guard")
3. 3
   Remove the engine room cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")
4. 4
   Disconnect the washer hose (B) and the washer motor connector (A).

   

5. 5
   Remove the washer reservoir inlet hose (A) after loosening the bolt.

   

6. 6
   Remove the washer motor (B) after disconnecting the fixing hook (A).

   

7. 7
   Remove the level sensor switch (A).

   

Installation

1. 1
   Install the washer reservoir.
2. 2
   Install the washer motor.
3. 3
   Install the washer hose.
4. 4
   Connect the washer motor connector and the level sensor connector.
5. 5
   Install the wheel guard and the guide cover. (Refer to Body - "Front Wheel Guard")
6. 6
   Install the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")
7. 7
   Check the operation of the washer motor.