Hyundai Kona Quiz
Four-Wheel Drive (4WD) System

Oil Hydraulic Motor (Actuator) Repair Procedures

In this manual: Four-Wheel Drive (4WD) System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
7steps
~42min
2/5difficulty
0102030405010.88N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Inspection

Oil Hydraulic Motor (Actuator) Inspection Procedure

Removal

  1. Remove the coupling assembly. (Refer to 4WD Control System – Coupling Assembly)
  2. Keep the coupling perpendicular after removing the coupling assembly.
  3. Remove the hydraulic motor (A) after first loosening the bolts with a hex key.

Installation

  1. Before installation, wipe the surface (A) with a clean cloth.
  2. Inspect the O-rings (A) of the new hydraulic motor (actuator).
  3. After installing the hydraulic motor (actuator), tighten the bolts (A).

    Tightening torque: 8.8–10.8 N·m

  4. Wipe off leaked oil from the surface with a clean cloth.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.