Sunroof Reset
It may be necessary to reset the sunroof in the following cases:
- The battery is discharged or disconnected, or the sunroof fuse has been replaced or removed.
- The sunroof control switch does not operate properly
To reset the sunroof, perform the following steps:
1. Turn the ignition switch to the ON position or start the engine. It is recommended to reset the sunroof with the engine running.
2. Push the sunroof control lever forward. The sunroof will fully close or tilt depending on the current sunroof condition.
3. Release the control lever until the sunroof stops moving.
4. Push the control switch forward again and hold it for approximately 10 seconds.
- When the sunroof is in the closed position:
The glass will tilt and move slightly up and down.
- When the sunroof is in the tilted position:
The glass will move slightly up and down.
Do not release the switch until the operation is complete.
If you release the lever during operation, try again starting from step 2.
5. Within 3 seconds, move the control lever forward until the sunroof operates as follows:
Tilt down, slide to open position, slide to closed position.
Do not release the switch until the operation is complete.
If you release the lever during operation, try again starting from step 2.
6. Release the sunroof control lever after all operations are complete. (The sunroof system has been reset.)
Information
- If the sunroof does not reset when the vehicle battery is disconnected or discharged, or the corresponding fuse has blown, the sunroof may not operate normally.
- For more detailed information, we recommend contacting an authorized HYUNDAI dealer.
Test yourself
A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.