Hyundai Kona Quiz
Suspension System (without ECS)

TPMS Receiver Repair Procedures

In this manual: Suspension System (without ECS)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
9steps
~54min
2/5difficulty
Done 0 of 9

Replacement

[TPMS Receiver (Body Control Module (BCM))]
  1. Turn the ignition OFF and disconnect the negative (-) battery cable.
  2. Remove the upper glove box cover. (Refer to Body - "Upper Glove Box Cover")
  3. Remove the smart key unit. (Refer to Body Electrical System - "Electronic Key Unit").
  4. Remove the body control module (A) by removing the bolt and nut.
  5. Disconnect the connectors from the Body Control Module (A).
  6. Install in the reverse order of removal.
  7. After replacing the receiver, learn it using the GDS scan tool.

Adjustment

Diagnostic Procedure Using the Scan Tool

As a guide to diagnostic methods using the scan tool, the main contents are as follows:
  1. Connect the 16-pin diagnostic connector located in the lower part of the driver side trim panel to the scan tool, then turn on the scan tool after turning the ignition key ON.
  2. Select "Vehicle Model" and "TPMS" on the GDS vehicle selection screen, then select OK. [Record Sensor ID]
    [Vehicle Name Input Initialization]
    [VIN Input Initialization]

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.