Hyundai Kona Quiz
Suspension System (without ECS)

Wheel Repair Procedures

In this manual: Suspension System (without ECS)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
3steps
~18min
2/5difficulty
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 3

Hub Nut Tightening Sequence

Tighten the hub nuts as follows.

Tightening torque: 107.9–128 N·m

Perform inspection
  1. Raise the vehicle.
  2. Measure the wheel runout using a dial indicator as shown in the illustration below.
    Run out Aluminum Steel
    Radial mm (in) Less than 0.3 (0.012) Less than 1.1 (0.043)
    Axial mm (in) Less than 0.3 (0.012) Less than 0.7 (0.027)
  3. If the measured value exceeds the specified value, replace the wheel.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.