Curtain Airbag (CAB) Module

Components and Component Location

Components

Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least 3 minutes before starting work.
2. 2
   Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly")
3. 3
   Disconnect the curtain airbag connector (A).

   

4. 4
   After loosening the mounting bolts and nuts, remove the curtain airbag.

   

Installation

1. 1
   Turn the ignition off.
2. 2
   Disconnect the negative battery cable and wait at least three minutes.
3. 3
   Tighten the curtain airbag mounting bolts. Tightening torque: Bolts: 7.8–11.8 N·m Nuts: 3.9–5.9 N·m

   Never twist the airbag module during installation. If the module is twisted, the airbag module may deploy abnormally.

4. 4
   Connect the curtain airbag connector.
5. 5
   Install the roof trim assembly. (Refer to Body - "Roof Trim Assembly")
6. 6
   Connect the negative battery cable.
7. 7
   After installing the curtain airbag (CAB), check that the system operates correctly: Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds and then turn off.