Front Seat Belt Pretensioner

Components and Component Location

Component Location

Repair Procedures

Replacement

When removing with a flat-blade screwdriver or puller, wrap the tool with protective tape to prevent damage to the components. Wear gloves to avoid cutting your hands.

1. 1
   Remove the lower center pillar trim. (Refer to Interior Trim - "Center Pillar Trim")
2. 2
   Remove the center pillar upper garnish. (Refer to Body Trim - "Center Pillar Garnish")
3. 3
   Loosen the mounting bolt and remove the front seat belt upper anchor (A).

   Torque: 39.2 – 54 N·m

   

4. 4
   Press the locking pin and disconnect the front seat belt pretensioner connector (A).

   

5. 5
   Remove the mounting bolt and remove the front seat belt pretensioner (A).

   Torque: 39.2 – 54 N·m

   

6. 6
   To install, reverse the removal procedure.

   After installing the front seat belt pretensioner, check that the airbag warning light comes on for approximately 6 seconds when the ignition is turned on and then goes off. Make sure the connector is properly connected. Replace any damaged clips (or pin-type retainers).