Hyundai Palisade Quiz
Body Electrical System

IMS (Integrated Memory System) Module

In this manual: Body Electrical System
General Information — 10Engine Mechanical System — 56Engine Electrical System — 28Emission Control System — 21Engine Control System/Fuel System — 42Automatic Transmission System (A8LF1) — 33All-Wheel Drive (AWD) System — 16Drive Shaft and Axle — 19Suspension System — 28Steering — 17Restraints — 20Brake System — 39Body (Interior and Exterior) — 142Body Electrical System — 171Heating, Ventilation, and Air Conditioning — 47Advanced Driver Assistance System (ADAS) — 44
6steps
~36min
2/5difficulty
Done 0 of 6

Components and Component Location

Components

Hyundai Palisade. Components and components location
IMS Input/Output Terminal Information
No Connector A Connector B Connector C
1 Seat Cushion Extension Motor (Front) B+ (Power) Seat Slide Motor Switch (Front)
2 Seat Recline Motor (Front) Ground (Power) Seat Tilt Switch (Front)
3 Seat Height Motor (Up) B+ (Power) Seat Recline Switch (Up)
4 Seat Slide Motor (Front) - Seat Height Switch (Up)
5 Seat Cushion Extension Motor (Rear) Ground Seat Cushion Extension Switch (Front)
6 Seat Recline Motor (Rear) B_CAN (High)
7 Seat Recline Motor (Up) B_CAN (Low)
8 Seat Recline Motor (Down) Lumbar Motor (Up)
9 Seat Height Motor (Down) Lumbar Motor (Down)
10 Seat Slide Motor (Rear) Seat Slide Sensor
11 Seat Recline Sensor
12 -
13 Seat Position Sensor Power
14 IGN 1
15 Seat Slide Switch (Rear)
16 Seat Recline Switch (Rear)
17 Seat Recline Switch (Down)
18 Seat Height Switch (Down)
19 Seat Cushion Extension Switch (Rear)
20 Ground
21 Lumbar Motor (Low)
22 IMS Switch 2
23 -
24 Seat Recline Sensor
25 Seat Height Sensor
26 -
27 -
28 Battery (+)

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")
  3. Remove the IMS module (B) after disconnecting the connector and loosening the screws (3 pcs).
    Hyundai Palisade. Repair procedures

Installation

  1. Install the IMS module after reconnecting the connector.
  2. Install the driver's seat.
    Hyundai Palisade. Repair procedures
    • Make sure that the connectors of the IMS module and the corresponding connectors are connected correctly.
    • Make sure that the IMS system operates normally.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Palisade quiz: every answer comes with an explanation and a link to the manual page.