Rear Console Cover

Components and Component Location

Component Location

Repair Procedures

Replacement

When removing with a flat-blade screwdriver or puller, wrap the tool with protective tape to prevent damage to the components. Wear gloves to avoid cutting your hands.

Use a plastic panel removal tool to remove the interior trim parts without damaging the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Using a flat-tip screwdriver or a remover, remove the rear console upper cover (A).

   

2. 2
   Disconnect the connector of the rear console upper cover (A) and remove the rear console upper cover (B).

   

3. 3
   To install, reverse the removal procedure.

   Make sure the connector is properly connected. Replace any damaged clips (or pin-type retainers).

When removing with a flat-blade screwdriver or puller, wrap the tool with protective tape to prevent damage to the components. Wear gloves to avoid cutting your hands.

Use a plastic panel removal tool to remove the interior trim parts without damaging the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Remove the rear console assembly (Refer to Floor Console - "Floor Console Assembly").
2. 2
   Loosen the mounting screws and remove the rear console lower cover (A).

   

3. 3
   Press the lock pin and disconnect the connector (A).

   

4. 4
   To install, reverse the removal procedure.

   Make sure the connector is properly connected. Replace any damaged clips (or pin-type retainers).