Sunroof Glass

Components and Component Location

Components

Repair Procedures

Replacement

[Front]

1. 1
   Slide the mechanism cover (A) in the direction of the arrow to align it with the groove (B), and remove it.

   

2. 2
   Adjust the height by loosening the height adjustment screw (A) of the glass.

   Unscrew the installed screw while tilting the movable glass.

   

3. 3
   Carefully lift the sliding glass (A) and remove it.

   

4. 4
   Install in the reverse order of removal.

   After replacing the sliding glass, adjust the alignment if necessary.

[Rear]

Wear gloves to protect your hands. Heat may be generated when working with the wires. Be careful not to burn your hands. Be careful not to disconnect the piano wire.

1. 1
   Cut the sealant at the edge (B) by pulling the piano wire (A) to the left and right.

   

2. 2
   Cut the sealant at (A-A), (B-B), (C-C) by pulling the piano wire (A) left and right, and remove the rear sunroof glass.

   

3. 3
   Install in the reverse order of removal.

   To make sure the applied sealant is fully cured, leave the vehicle on a level surface for at least 4 hours after windshield installation. If driving the vehicle is unavoidable, drive at low speed for at least 8 hours. Advise the driver to avoid aggressive driving or driving on rough roads for 2-3 days after windshield installation.