Rear Stabilizer Bar Repair Procedures

DEPOSIT

1. 1
   Remove the front wheel and tire assembly (A) from the hub.

   Tightening torque: 88.3 ~ 108 N·m

   

2. 2
   Remove the stabilizer bar (A).

   Tightening torque: 98.1 ~ 118 N·m

   

3. 3
   Remove the carrier. [4WD only] (See Axle and Propeller Shaft - "Differential Carrier")
4. 4
   Loosen the mounting bolt, then remove the stabilizer bar from the subframe.

   Tightening torque: 44.1~54 N·m

   

5. 5
   To install, perform the removal procedure in reverse order.

Inspection

1. 1
   Make sure that the rear stabilizer bar is not deformed.
2. 2
   Make sure that the rear stabilizer bar link ball joint is not damaged.