Brake Line

Components and Component Location

COMPONENTS

LEFT-HAND DRIVE

(DIRECT DRIVE)

Repair Procedures

DEPOSIT

1. 1
   Disconnect the brake fluid level switch connector and remove the reservoir cap.
2. 2
   Drain the brake fluid from the master cylinder reservoir using a syringe.
3. 3
   Remove the wheel and tire.
4. 4
   Remove the brake hose clamp (A).
5. 5
   Disconnect the brake hose by loosening the hose flare nut (B).

   Tightening torque: 12.7 - 16.7 N·m

   FRONT

   

   REAR

   

6. 6
   Disconnect the brake hose (A) from the brake caliper by removing the bolt.

   Tightening torque: 24.5 ~ 29 N·m

   FRONT

   

   REAR

   

Inspection

1. 1
   Make sure the brake hoses are not cracked, kinked or corroded.
2. 2
   Make sure the brake lines are not cracked or damaged and there is no fluid leakage.
3. 3
   Make sure the flare nuts of the brake pipe are not damaged and there is no fluid leakage.
4. 4
   Make sure the brake hose mounting bracket is not cracked or deformed.

REMEDY

1. 1
   To install, perform the removal procedure in reverse order.

   

2. 2
   After installation, bleed the brake system. (Refer to Brake System - "Brake System Bleeding")
3. 3
   Make sure the brake fluid does not leak.