Hyundai Tucson Quiz
Braking System

Vacuum Pump

In this manual: Braking System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
8steps
~48min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Components and Component Location

COMPONENTS

[T-GDI ENGINE ONLY]
1. Vacuum Pump 2. Bracket

Repair Procedures

DEPOSIT

  1. Turn the ignition key to the OFF position and disconnect the negative (-) battery cable.
  2. Remove the lower covers (A).

    Tightening torque: 7.8 ~ 11.8 N·m (0.8 ~ 1.2 kgf·m, 5.8 ~ 8.7 ft-lbf)

  3. Disconnect the vacuum pump connector (A).
  4. Disconnect the vacuum hose (A), then remove the clamp on the vacuum hose (B).
  5. Loosen the power steering pump mounting nut and bolt (A), then remove the power steering pump assembly from the pump bracket.

    Torque: 19.6 ~ 29 N·m

  6. Remove the 2 bolts and the vacuum pump bracket.

REMEDY

  1. To install, perform the removal procedure in reverse order.
  2. Tighten the vacuum pump mounting bolts to the specified torque.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.