Parking Brake Assembly Repair Procedures

DEPOSIT

1. 1
   Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the front wheel and tire assembly (A) from the hub.

   Tightening torque: 88.3 ~ 108 N·m

   

3. 3
   Remove the rear brake caliper and brake disc. (Refer to Brake System - "Rear Disc Brake").
4. 4
   Loosen the bolt (B), then remove the clip (A) to disconnect the parking brake cable.

   

5. 5
   Remove the shoe hold-down pin and spring (A) by pressing down on the spring and turning it.

   

6. 6
   Remove the upper return spring (A) by turning the lever assembly (B).

   

7. 7
   Remove the adjuster assembly (B) and the return spring.

   

8. 8
   To install, perform the removal procedure in reverse order.

ITEM

1. 1
   Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the front wheel and tire assembly (A) from the hub.

   Tightening torque: 88.3 ~ 108 N·m

   

3. 3
   Remove the drum cover.

   

4. 4
   Turn the adjuster gear with a screwdriver until the disc no longer moves, then turn it 3 notches in the opposite direction.

   

5. 5
   Install the tire and wheel after installing the cover on the disc.
6. 6
   If the parking brake shoe or disc brake is replaced, the shoe must be broken in.

   1. With a force of 69 N (7 kgf, 15 lbf) applied to the parking brake, drive the vehicle 500 m (0.31 mile) at a speed of 60 km/h.
   2. Repeat the above procedure more than two times.
   3. The vehicle must be held on a 30% uphill grade.