Parking Brake Lever Repair Procedures

DEPOSIT

1. 1
   Fully release the parking brake.
2. 2
   Remove the floor console assembly. (Refer to Body group - "Floor Console")
3. 3
   Remove the parking brake cable (B) after removing the equalizer (B).

   

4. 4
   Disconnect the parking brake switch connector (A).

   

5. 5
   Remove the parking brake lever assembly (A) after removing the bolts.

   Torque: 19.6 ~ 29 N·m

   

REMEDY

1. 1
   To install, perform the removal procedure in reverse order.

   Specified grease: Multi-purpose grease SAE J310, NLGI No. 2

   

2. 2
   Perform "Parking Brake Lever Travel Adjustment".

ITEM

1. 1
   Install the parking brake cable adjuster, then adjust the parking brake lever travel by turning the adjusting nut (A). Parking brake lever travel: 6~7 clicks (pull the lever with a force of 196 N (20 kgf, 44 lbf))

   

   

2. 2
   Fully release the parking brake lever and check that the parking brake does not drag when the rear wheels are turned. If necessary, repeat the adjustments.
3. 3
   Make sure the parking brake is fully applied when you fully raise the parking brake lever.