Hyundai Tucson Quiz
Body Electrical System

Rear Combination Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
10steps
~60min
3/5difficulty
Done 0 of 10

DEPOSIT

  1. Disconnect the negative (-) battery terminal.
  2. Remove the outer rear combination light cover (A).
  3. Remove the outer rear combination light (A) after loosening the bolts.
  4. Remove the outer rear combination light (B) after disconnecting the connector (A).
  5. Remove the bulb (A) by turning it counterclockwise. [LED Type]
    [Bulb Type]
  6. Disconnect the connector of the inner rear combination light (A) after removing the trunk lid trim.
  7. Remove the inner rear combination light after loosening the nuts.
  8. If the bulb must be replaced, replace the bulb after removing the trunk lid trim.

REMEDY

  1. Install the inner light unit after installing the bulb.
  2. Install the rear combination light assembly after installing the bulbs and connecting the bulb connector.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.