Hyundai Tucson Quiz
Body Electrical System

Overhead Console Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
6steps
~36min
2/5difficulty
Done 0 of 6

Inspection

  1. Place the console assembly on the roof and check continuity between the terminals. If continuity does not meet the specification, replace the reading lamp switch.

DEPOSIT

  1. Disconnect the negative (-) battery terminal.
  2. Remove the mounting screws (2 pcs). Then remove the dome lamp console (A).
  3. Remove the overhead console after disconnecting the connector (A).
  4. Remove the lamp from the roof console (B) by turning the socket.

REMEDY

  1. Install the bulb in the dome lamp console assembly after connecting the connector.
  2. Install the lens, tightening the 2 screws.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.