Hyundai Tucson Quiz
Body Electrical System

Hazard Warning Switch Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Check continuity between the terminals. If continuity is not specified, replace the hazard switch.
    Hazard warning switch (type A)
    NO Description NO Description
    1 Battery (+) 9 ILLUMINATION (-)
    2 IG (ignition) 10 With Hazard Warning Switch
    3 - 11 -
    4 PASSENGER SEAT BELT INDICATOR 12 -
    5 - 13 -
    6 - 14 -
    7 Hazard Warning Light 15 -
    8 MASS 16 ILLUMINATION (-)

    Hazard Warning Switch (Type B)
    NO Description NO Description
    1 Battery (+) 5 ILLUMINATION (-)
    2 IG (ignition) 6 With Hazard Warning Switch
    3 Hazard Warning Light 7 PASSENGER SEAT BELT INDICATOR
    4 MASS 8 ILLUMINATION (-)

DEPOSIT

  1. Disconnect the negative (-) battery terminal.
  2. Using a screwdriver or removal tool, disconnect the switch from the hazard warning light (A) bezel.
  3. Remove the hazard warning switch after disconnecting the hazard switch connectors (A) and hose (B).
  4. Remove the hazard warning switch (B) after disconnecting the retaining clips (A).

REMEDY

  1. Install the hazard warning switch.
  2. Install the hazard warning switch.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.