Hyundai Tucson Quiz
Engine Mechanical System

Engine Mounting

In this manual: Engine Mechanical System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
19steps
~114min
4/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 19

Components and Component Location

COMPONENTS

1. Engine mounting
2. Engine mounting bracket		 3. Roller arm support
4. Transaxle support

Repair Procedures

Removal and Installation

Engine mounting bracket
  1. Remove the engine undercover. (Refer to Engine and Transaxle Assembly - "Engine Undercover")
  2. Install a jack to the oil pan protrusion to support the engine.
  3. Disconnect the ground cable (A).

    Tightening torque: 10.8 ~ 13.7 N·m

  4. Remove the engine mounting bracket (A). Tightening torque: Nuts (B), bolt (C): 88.3 ~ 108 N·m
  5. Remove the engine mounting bracket (A).

    Tightening torque: 63.7 ~ 83 N·m

  6. To install, perform the removal procedure in reverse order.
  7. Remove the engine undercover. (Refer to Engine and Transaxle Assembly - "Engine Undercover")
  8. Remove the roller arm bracket (A). Tightening torque: Nut (B): 107.9 ~ 128 N·m Bolts (C): 49.0 ~ 64 N·m
  9. Remove the roller rod mounting bracket (A).

    Tightening torque 49.0 ~ 69 N·m

  10. To install, perform the removal procedure in reverse order.
  11. Remove the air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleaner")
  12. Disconnect the battery and battery tray. (Refer to Engine Electrical System - "Battery".)
  13. Install the jack to the edge of the transaxle.
  14. Remove the front wheel arch. (Refer to Body - Body Side Molding.)
  15. Remove the cover (A).
  16. Remove the bolts (A) of the transaxle mounting bracket.

    Tightening torque: 88.3 ~ 108 N·m

  17. Remove the transaxle mounting bracket (A).

    Tightening torque 58.9 ~ 78 N·m

  18. Remove the transaxle mounting bracket (A).

    Tightening torque 63.7 ~ 83 N·m

  19. To install, perform the removal procedure in reverse order.
Roller arm bracket / Transaxle mounting bracket

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.