Hyundai Tucson Quiz
Body Electrical System

Blind Spot Detection Indicator

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 51Engine Electrical System — 26Emission Control System — 23Engine/Fuel Control System — 44Clutch System — 12MANUAL TRANSMISSION SYSTEM — 12AUTOMATIC TRANSMISSION SYSTEM — 42Four-Wheel Drive (4WD) System — 14Drive Shaft and Axle — 22Suspension System — 30Steering System — 16Restraint — 21Braking System — 47Body Work (Interior and Exterior) — 145Body Electrical System — 162Heating, Ventilation and Air Conditioning — 39
8steps
~48min
2/5difficulty
Done 0 of 8

Components and Component Location

COMPONENTS

1. BSD Indicator
2. Side Marker Lamp		 3. Floor Lamp Bottom

Repair Procedures

DEPOSIT

Blind Spot Detection Warning Indicator
  1. Disconnect the negative (-) battery terminal.
  2. Remove the mirror (A).

REMEDY

Blind Spot Detection Warning Indicator
  1. Install the outside mirror.
  2. Connect the negative (-) battery terminal.

Inspection

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front mirror interior trim (A).
  3. Disconnect the power outside mirror connector from the wiring harness.
  4. Apply battery voltage to each terminal as shown in the illustration and make sure the mirror operates correctly. [BSD Indicator]

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.