Body Electrical System

Power Window Switch

25steps
~150min
4/5difficulty
Done 0 of 25

Components and Component Location

COMPONENTS

Driver Window Switch
Passenger Window Switch
Rear Power Window Switch

Circuit Diagrams

Wiring Diagram

Driver Power Window Switch

[Driver Window Switch (Safety)]

[Driver Window Switch (Auto Down)]

Passenger Window Switches

Rear Power Window Switch

[Rear Window Switch (Manual)]

[Rear Window Switch (Manual + Seat Heater)]

Repair Procedures

Inspection

Driver Window Switch
  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver's door trim panel. (Refer to Body - Front Door Trim Panel)
  3. Disconnect the power mirror switch connector from the door trim panel.
  4. Check the continuity between the terminals at each switch position as shown below. [Window Switch Inspection]
    [Power Door Lock Switch Inspection]
    [Window Lock Switch Inspection]
  5. Disconnect the negative (-) battery terminal.
  6. Remove the passenger door trim panel. (Refer to Body - "Front Door Trim Panel")
  7. Disconnect the power mirror switch connector from the door trim panel.
  8. Check the continuity between the terminals at each switch position as shown below.
  9. Disconnect the negative (-) battery terminal.
  10. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  11. Disconnect the power mirror switch connector from the door trim panel.
  12. Check the continuity between the terminals at each switch position as shown below. [Rear Power Window Switch Inspection]
    [Rear Seat Heater Switch Inspection]
Passenger Window Switch Rear Window Switch

DEPOSIT

Driver and Passenger Window Switches
  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to Body - "Front Door Trim")
  3. Loosen the set screws.
  4. Remove the armrest from the door trim panel (A).
  5. Remove the power window switch assembly (A).
  6. Loosen the mounting screws, then remove the power window switch (A).
  7. Disconnect the negative (-) battery terminal.
  8. Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
  9. Loosen the mounting screws, then remove the power window switch (A).
Rear Power Window Switch

REMEDY

Driver and Passenger Window Switches
  1. Install the power window switch.
  2. Install the front door trim panel after connecting the connector.
  3. Install the power window switch.
  4. Install the rear door trim panel after connecting the connector.
Rear Power Window Switch

Test yourself

A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.