Body Electrical System
Window Regulator Motor
In this manual: Body Electrical System
9steps
~54min
3/5difficulty
Done 0 of 9
Components and Component Location
COMPONENTS

Circuit Diagrams
Wiring Diagram

Repair Procedures
Inspection
FRONT WINDOW REGULATOR MOTOR- Disconnect the negative (-) battery terminal.
- Remove the front door trim panel. (Refer to Body - "Front Door Trim")
- Disconnect the motor connector from the motor.

- Connect terminal No. 2 and No. 3 to battery voltage (12 V) and check that the motor operates normally when the terminals below are connected. [Safety Window Motor]

- Connect the motor terminals to battery voltage (12 V) and check that the motor operates smoothly. Then reverse the polarity and check that the motor operates normally in the reverse direction. If the motor does not operate normally, replace it. [Standard Window Regulator]

- Disconnect the negative (-) battery terminal.
- Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
- Disconnect the motor connector from the motor.

- Connect motor terminals No. 1 and No. 2 directly to battery voltage (12 V) and check that the motor operates smoothly. If the motor does not operate normally, replace it. [Standard Window Regulator]

Test yourself
A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?